HQ Marking Felt, 2-Pack – 375 × 500 mm (10″ × 19″)

The felt is the part of an electrochemical marking system that nobody thinks about until it slows the job down. It holds the electrolyte, carries the current to the part, and absorbs the by-products of every mark you make. Once it is saturated, mark quality drops and the operator has to stop, wash it, and wait.

HQ felt is built to delay that moment.

Why it matters on a production run

Standard SQ felt saturates relatively quickly. On a continuous run, that means repeated interruptions — wash, wait, refit, resume. Each stop is short, but across a shift they add up to real lost time, and they are the reason manual marking often gets estimated as slower than it actually is.

HQ felt holds marking by-products considerably longer. Fewer washes, fewer replacements, and the operator stays with the parts instead of at the sink.

Where the difference shows

HQ felt earns its cost on any job where marking is continuous rather than occasional. Batch production, serialised parts, pre-delivery marking of a full order — anywhere the operator is making mark after mark rather than one every so often.

For occasional or light-duty use, standard SQ felt is the sensible choice.

Specification

Two sheets per pack

375 x 500 mm (10″ x 19″) each

Cut to size for any EUmark marking head

Compatible with M21, M22 and M23 electrolytes

Fits all EUmark marking systems: Set 01, 02, 03, 05, 06, 07 and SUPER SET 04.